IKA LOGIC IkaScope WS200 Datasheet And User Manual page 13

IkaScope WS Ultra portable oscilloscope WS
Figure : Ikascope application screenshot
Note: IkaScope device must be turned ON to be connected to a network. If all LEDs are switched
OFF, please turn ON IkaScope by pressing on the probe tip for second. Finally, press IkaScope probe
tip on the pad where an electric signal needs to be measured. You should hear a "click" sound, and
feel a vibration in the device: This means that data is being streamed to the application. Keep the
pressure on the tip until you see signals appearing in the application (This can take between and
milliseconds).
(c) Ikalogic SAS