Table of Contents
Advertisement
Section 1: Introduction
September 2019
Section 1: Introduction
This manual is valid only for ER5K kits ER5K-XXXX. The instructions for individual components
must also be read and followed and are either attached in the appendix or supplied separately.
Section 2: Before You Begin
WARNING
This device is not intended for or rated for use in hazardous locations.
1. Please contact your TESCOM representative for Explosion Proof options.
2. Avoid personal injury or property damage from sudden release of pressure or
2.1
Safety, Installation and Operations Precautions
2.1.1
TESCOM Electronic Controllers
WARNING
Do not attempt to select, install, use, or maintain this controller, or accessory until you have
read and fully understood these instructions. Be sure this information reaches the operator
and stays with the product after installation. Do not permit untrained personnel to install,
use, or maintain this controller, or accessory. Improper selection, installation, maintenance,
misuse, or abuse of this controller, or related accessories can cause death, serious injury,
and/or property damage. Oxygen service requires special expertise and knowledge of
system design and material compatibility in order to minimize the potential for death,
serious injury, and/or property damage.
1
bursting parts. Before proceeding with any installation procedures:
•
Always wear protective clothing, gloves, and eyewear to prevent personal
injury, or property damage.
•
Do not remove the ER5000 or any other component of the system while the
system is pressurized.
•
Disconnect any operating lines providing air pressure, electric power, or a
control signal to the ER5000 prior to installation or maintenance.
•
Use bypass valves or completely shut off the process to isolate the ER5000
and associated equipment from process pressure prior to installation or
maintenance. Relieve process pressure on both sides of the controller and
associated equipment.
•
Use lock-out procedures to be sure that the above measures stay in effect
while you work on the equipment.
•
Check with your process or safety engineer for any additional measures that
must be taken to protect against process media dangers.
Do not install, operate, or maintain an ER5000 controller, or any associated
equipment, without reading and fully understanding the installation guidelines
and operating instructions for every component of your application. To avoid
personal injury or property damage, it is important to carefully read, understand,
and follow all contents of this Getting Started guide, including all safety cautions
and warnings. If you have any questions about these instructions, contact your
TESCOM sales office before proceeding.
ER5K Kits
DOPSM2095X012
Section 1: Introduction
Advertisement
Table of Contents
