Table of Contents
Advertisement
9. From the Setup menu, select Avionics Equipment (5<Enter>):
a. From the Equipment menu, select Browse All Avionics (1 <Enter>).
The system will step you through each equipment sub-menu (see paragraph 4.4.1.5 for all
Avionics Equipment sub-menus. There are too many menus to show here). As you select the
equipment the next equipment menu in the loop will appear.
As each sub-menu appears you must make a selection to continue
stepping through the equipment (even if the correct selection is already
in brackets). Selecting Back (x <Enter>) will cause it to go backwards to
the last sub-menu.
Once you have stepped through all sub-menus, the equipment menu will reappear.
b. Verify the equipment shown in parentheses under each equipment title matches the wiring
interface. To change equipment source, select it from the menu and make changes.
c. Select Back (x<Enter>) until the Save or Revert menu appears. Select Save Changes (S <Enter>)
to keep current configuration. (Selecting Revert to Old Settings will cause system to exit the
service menu without saving changes.)
009-11900-001
Revision F
The document reference is online, please check the correspondence between the online documentation and the printed version.
SKY899
Installation Manual
Equipment
1 Browse All Avionics
2 GPS Nav
[None]
3 Magnetic Heading
[None]
4 Barometric Altitude
[Encoding Altimeter]
5 Radio Altitude
[None]
6 Landing Gear
[Active Low]
7 Weight-On-Wheels
[Active Low]
8 Audio Suppression
[Active Low]
9 External Display
[None]
x Back
Choice:
NOTE
Save or Revert
Changes have been made!
S Save Changes
R Revert to Old Settings
Choice:
Appendix F - Page F-7
July 18, 2013
Advertisement
Table of Contents
