Table of Contents
Advertisement
d. Move the T-49C to each test point and verify that the display shows the corresponding bearing
displacement.
It is necessary to wait a few seconds after moving to let the test target
stabilize in position.
21. This completes testing with the T-49C, reattach top lid of the T-49C.
22. If installed, TURN ON the radio altimeter.
23. This completes the post installation checkout procedure.
009-11900-001
Revision F
The document reference is online, please check the correspondence between the online documentation and the printed version.
SKY899
Installation Manual
NOTE
Appendix D - Page D-5
July 18, 2013
Advertisement
Table of Contents
