Table of Contents
Advertisement
8. To manually configure each receiver channel:
a. With all (ARINC 429 source) avionics equipment turned on, select the ARINC 429 receiver
channel to be configured. The ARINC 429 receiver channel menu will appear.
When selecting equipment type for a receiver channel that the speed was
previously set the Speed menu will not automatically appear after
equipment type is selected. Select speed to change receiver channel
speed.
Arinc 429 Rx Ch 1
1 Type :
GPS
2 Speed: 100
x Back
Choice:
b. From ARINC 429 Rx Ch menu, select Type (1 <Enter>) from the menu.
c. From Equipment Type menu, select source equipment from the list (1-5 <Enter>) (i.e., GPS,
BarAlt, etc.).
d. If the speed menu appears, select the correct speed, otherwise proceed to next step.
e. From the ARINC 429 Rx Ch menu, verify receiver channel matches desired interfaced equipment
type, speed and channel wiring. If connected to an ARINC-429 super bus, select all of the
equipment that is located on that bus before configuring another receiver channel.
f. Repeat above steps a thru d for each receiver channel input that is connected.
g. Select Back to return to Setup Menu.
Page F-6 - Appendix F
July 18, 2013
The document reference is online, please check the correspondence between the online documentation and the printed version.
SKY899
Installation Manual
Arinc 429 Rcvrs
0 Autodetect
1 Ch.1: GPS
2 Ch.2: Multi
3 Ch.3: NoType
4 Ch.4: NoType
5 Ch.5: NoType
x Back
Choice:
NOTE
Equipment Type
1 NoType
2 BarAlt
3 MagHdg
kHz
<4 GPS >
5 RadAlt
x Back
Choice:
100
kHz
100
kHz
NoSpeed
NoSpeed
NoSpeed
Speed
1 12.5 kHz
<2 100k Hz>
Choice:
009-11900-001
Revision F
Advertisement
Table of Contents
