2.
Pull out the tray extension, and open the paper guides.
3.
Insert the paper into Tray 1 (MPT), and adjust the paper guides to fit the paper.
■
The paper can be loaded with either the long or short edge entering first, as shown in
the illustrations.
■
The maximum width (X) is 212.5 mm (8.5 in.).
■
For single-sided printing, if you are using preprinted or prepunched paper, place the
side to be printed facedown with the top of the paper entering the printer first.
■
For 2-sided printing, if you are using preprinted or prepunched paper, place the first
side to be printed faceup with the bottom of the page entering the printer first.
Long-Edge Feed
4.
On the control panel, select
5.
Select the paper type, and then press the OK button.
6.
Do one of the following:
■
If your custom paper size is listed in the menu, select it, and then press the OK button.
■
If your custom paper size is not listed in the menu, select
then press the OK button.
X
H
6300-111
Change
setup, and then press the OK button.
Phaser® 6300/6350 Color Laser Printer
3-40
Printing on Specialty Media
6300-007
X
H
6300-112
Short-Edge Feed
New Custom
Size, and