Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZKTeco L 6800
Summary of Contents for ZKTeco L 6800
- Page 1 Installation Instruction L 6800...
-
Page 2: Before Installation
Before Installation Lock Diagram... -
Page 3: Packing List
Packing List... -
Page 4: Door Preparation
Door Preparation 1. Check door thickness; prepare proper screws and spindles. Door Thickness D Spindles C Spindle I Screws 35 - 45 mm 40 mm 75 mm 25 mm Note: If the door thick er than 35 45 this lock shall not be applicable. 2. - Page 5 Cautions 1 New lock is defined as always open mode until it is locked once by mifare card. 2 Please swipe authorised card, time sync card, room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place.
-
Page 6: Installation
Installation 1. Drill holes on the door 2. Remove the mortise latch plate (J) center line of the handle Note 1: Align the template along the vertical center line of the mortise (H) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling. - Page 7 3. Install mortise (H)
- Page 8 4 Install lock cylinder (G) 4 Install lock cylinder (G) 5 Install spindle (D) 5 Install spindle (D) and stud B and stud B Note: Ensure the two triangles are in horizontal alignment.
- Page 9 6 Install outdoor unit (A) 6 Install outdoor unit (A) 7 Install spindle (C) and (D) 7 Install spindle (C) and (D)
- Page 10 9 Install the battery (R) and 9 Install the battery (R) and 8 Install indoor unit (N) 8 Install indoor unit (N) plastic plastic cover (O) and (P) cover (O) and (P)
- Page 11 10 Mark and drill holes for strike 10 Mark and drill holes for strike...
- Page 12 11. Test Lock by mechanical key (S) Step1: Remove the cover on the key hole with a sucker ( T ). Step2: Insert mechanical key (S) into the key hole and rotate it at 90°.
- Page 13 © Copyright 201 . ZKTeco Inc. ZKTeco Logo is a registered trademark of ZKTeco or a related company. All other product and company names mentioned are used for identification purposes only and may be the trademarks of their respective owners. All specifications are subject to change without notice. All rights reserved.