Download Print this page

Advertisement

Quick Links

Installation Instruction
LH3000
Version: 1.0
Date: Nov. ,2016

Advertisement

loading
Need help?

Need help?

Do you have a question about the LH3000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ZKTeco LH3000

  • Page 1 Installation Instruction LH3000 Version: 1.0 Date: Nov. ,2016...
  • Page 2: Before Installation

    Before Installation Diagram...
  • Page 3: Packing List

    PackingList 5.5mm 45 mm 20 mm 40 mm 67mm...
  • Page 4: Door Preparation

    Door Preparation 1. Check door thickness, prepare the proper screws and spindles. Door Thickness E Spindles R Screws P Spindle 35-55 mm 40 mm 45 mm 67 mm Note: If out of the door thickness of 35-55 mm,this lock will not be available. 2.
  • Page 5 Cautions 1. New lock is defined as always open mode until it was unlocked once by mifare card. 2. Please swipe authorised card,time sync card,room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place.
  • Page 6: Installation

    Installation 1. Drill holes on the door 2. Remove the mortise latch plate (H) center line of the handle backset 62.5 mm Note 1: Align the template along the vertical center line of the mortise (F) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling.
  • Page 7 4. Install lock cylinder (D) 3. Install mortise (F) Note: Ensure the two triangles are in horizontal alignment.
  • Page 8 5. Install spindle (E) 6.Install outdoor unit (C)
  • Page 9 8.Install indoor unit (Q) 7.Install spindle (E) and (P)
  • Page 10 9.Install the battery (K) and mortise latch plate (H)
  • Page 11 10. Mark and drill holes for strike 25 mm...
  • Page 12 11. Test Lock by mechanical key (B) Step1: Remove the cover on the key hole with tape. Step2: Insert mechanical key (B) into the key hole and rotate it at 90°.