Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZKTeco AL30B
Summary of Contents for ZKTeco AL30B
- Page 1 Installation Guide AL30B & AL40B Version: 1.0...
-
Page 2: What's In The Box
1. What’s In the box Outdoor unit Indoor unit Gasket Latch Keys Strike Strike plate Note: To ensure proper functioning of the lock, use the correct set of screw C as per your door thickness. Mounting plate Screw B Screw length For door thickness Screw C Screw A... - Page 3 2. Installation Diagram (AL30B) Door Indoor Battery (not included) unit Gasket Screw C Battery cover Outdoor unit Screw A Screw B Latch Strike box...
-
Page 4: Installation Steps
3. Installation steps Important notes. Please read all the instructions in this manual or call customer care before returning the product to the store. Whenever you install this lock on any door, you must perform the initialization process just after the installation as described in Initialization step on page 10. -
Page 5: Drilling Holes In The Door
Drilling holes in the door. 1. Paste the installation template at a desired handle height. 2. Mark the holes and start drilling the holes. - Page 6 Adjust the backset of the lock to 70mm (if needed). Backset is the distance from the edge of the door to the center of the hole drilled on the door. The default backset is 60mm, if you want to change the backset to 70mm backset, grasp body and twist faceplate as shown below: Press the bolt inside the latch Rotate the faceplate...
-
Page 7: Installing The Latch
Installing the latch. Secure the latch by inserting the screws B. Before installing the latch, make sure the latch bolt is in extended (Locked) position and the UP arrow direction is facing upwards. - Page 8 Installing outdoor unit on the door. Before inserting the unit inside the door, make sure Firstly route the cable under the bolt through the the highlighted spindle is in the vertical position as drilled hole. Then attach the outdoor unit to the shown.
- Page 9 Installing mounting plate with gasket on the door. Attach the mounting plate to the gasket and route Place the gasket and mounting plate on to the cable through the hole on the mounting plate the door and use screws C to secure them. and gasket.
-
Page 10: Installing The Indoor Unit
Installing the indoor unit. Connect the cable connector to the port on Place the indoor unit properly on the mounting plate, indoor unit. push and adjust the excess cable to the left. Then use screws A to secure indoor unit. The knob dot must be in direction of bolt. -
Page 11: Insert Batteries
Insert batteries. Initialization of lock. Insert four 1.5V alkaline batteries After installing the lock, you must perform initialization and install the battery cover. process as explained in below steps: 1. Press and hold the reset button, then remove one battery and place it back again, keep holding until the lock prompts “Restore to default settings, wait a moment. - Page 12 Mark and drill holes for the strike box and plate. Make sure that the strike box is in level of latch Align the strike box and plate with the drilled hole bolt, then use installation template to drill holes. and use screws B to secure them. Depth 2mm (10/127 “) 33mm...