Internet/cellular programmable video telephone/access control system (18 pages)
Summary of Contents for DoorKing 1620 Series
Page 1
Used with 1601 Barrier Gate Operator THIS PRODUCT IS TO BE INSTALLED AND SERVICED BY A TRAINED GATE/DOOR SYSTEMS TECHNICIAN ONLY. WITHOUT Convenience Open, Visit www.doorking.com/dealer-locator to find a professional installing and servicing dealer in your area. WITH Manual Release to Enhance Vehicular Traffic...
Table of Contents DoorKing Safety for Lane Barrier Safety and Traffic Management for Lane Barrier System Layout Entry Lane Only In-Ground Loop Options Install Traffic Light (Required) Install Octagon Arm Install Photocell (Required) Opening Operation (Green Lights) Closing Operation (Red Lights)
DoorKing Safety for Lane Barrier • DKS Lane Barrier System is NOT crash rated. It is intended to provide a formidable barrier to help prevent passenger vehicles and light-duty trucks from driving through a controlled traffic lane. Moving Gate Can Cause •...
Safety and Traffic Management for Lane Barrier System Vehicular lane barrier gate operator can produce high levels of force. It is important that Arm Red/Green LED Lights: Helps with arm’s visibility and you are aware and eliminate possible HAZARDS; Pinch Points, Entrapment Areas, position.
SERIAL 14 ft Lane: Use 34 counterweights (17 on each side) VOLTS PHASE AMPS 60 Hz MAX GATE LOAD DoorKing, Inc., Inglewood, CA Secondary Arm Rod d a r Moving Gate Can Cause Serious Injury or Death c o n...
Page 7
SERIAL VOLTS PHASE AMPS 60 Hz MAX GATE LOAD Sleeve DoorKing, Inc., Inglewood, CA Anchor Photocell Beam Moving Gate Can Cause Serious Injury or Death KEEP CLEAR! Gate may move at any time Secondary Barrier Arm (Up Position) without prior warning.
DoorKing's web site for more information. www.doorking.com TIME DELAY Loop detector wiring shown is for DoorKing model 9409 Dual Channel plug-In loop detector only. LOOP If using other loop detectors refer to their Loop Information Manual for installation instructions, loops/preformed loops and wiring diagrams.
Install Traffic Light (REQUIRED) Assemble Support Post Mount Support Post on OPPOSITE Side of Access Door Wire Light to Operator c e s Red/Brown White o r t Traffic Light Terminal Traffic Light Black Green Traffic Light Cable Existing Bracket o l t Bolts t i n...
Drawings NOT to scale. Install Octagon Arm Install Arm & Reverse Edge (REQUIRED) Install End Cap Push a screwdriver Install Arm Cover Test hub UP and DOWN position through the hole in the IMPORTANT: Wire harness MUST Allow arm to protrude before installing arm bracket.
3 screws to help keep the Beam Sensors REVERSE 1601-010 GREEN LED ON if necessary. SENSITIVITY Terminal #5 Note: DoorKing Retro-Reflective Exceeding 250 mA DOWN Photocell (P/N 8080-057) LOOP of power from this S6 AC10-25V NO NC COM...
Opening Operation (Green Lights) I S E A r m t u r This occurs after access control device has approved entry. t u r L i g f f i c T r a N IN W AR VI NG e ve 53382 S TO...
Closing Operation (Red Lights) This occurs after vehicle has exited lane barrier area. t u r L i g f f i c T r a a n d A r m t u r N IN W AR VI NG e ve 53382 S TO...
Manual Release Operation 1. Unlock and remove access door. 2. Remove crank tool from inside access door. 3. Flip interlock assembly door up, power will be disabled from operator. 4. Insert crank tool into motor pulley as shown. 5. Rotate crank tool to manually move operator arms up or down. a th V IN h ic...
White Limit Sensor Brown White Reverse Edge/LED Lights Octagon Arm Down Limit Magnet Traffic Light (White Dot) Terminal DoorKing Retro-Reflective Photocell (P/N 8080-057) 1601-010 Terminal #5 Note: POWER c e s Exceeding 250 mA Traffic of power from this Light...
Page 16
Used with 1601 Barrier Gate Operator THIS PRODUCT IS TO BE INSTALLED AND SERVICED BY A TRAINED GATE/DOOR SYSTEMS TECHNICIAN ONLY. Visit www.doorking.com/dealer-locator to find a professional installing and servicing dealer in your area. WITHOUT Convenience Open to Enhance Traffic Control Management www.doorking.com...