Twisted Hobbys GYM-STAR HIGH WING 3D TRAINER Manual page 10

.... reconnect the battery to the ESC
and listen for two quick short beeps,
immediately following the beeps,
move the Throttle stick to low
position.
Next you should hear a series of
tones to indicate that programing is
complete.
Re-bind the system and double check
correct operation of all components.
Set up a Dual Aileron type Wing
Center all servos as close to 90 deg
as possible. Install the Longest single
arms on the servos.
We start by laying out the 6 wing parts as We apply Welder Adhesive to the top Smear Welder Adhesive as show to the
shown. matting hinge of the elevator as shown hinge only
10
Rev: 2013.06.25.v001b