Table of Contents
Advertisement
The splicer suddenly shut down
Fiber identification errors under
AUTO mode
The estimated loss is different from
the real loss
Heat shrinkable tube doesn't shrink
completely
How to cancel heating
The heat shrink tubing is stuck in
the heating tank after heating
Forget password
The splicer turned off automatically when the machine
is set for automatic machine shutdown (default 30
minutes) without any operations.
AUTO mode only for standard SM, MM, NZ optical
fibers. When splice special fibers, AUTO mode may
not recognize correctly.
1) The estimated loss is evaluated just for reference.
2) The optical components needed to be cleaned.
Extend the heating time.
If user want to terminate the heating, press HEAT
button, then the LED light will turn off.
Remove the heat shrink tubing with a thin cotton swab
or soft bar.
Contact agent or distributor.
50
Advertisement
Table of Contents
