Table of Contents
Advertisement
Error message
Reason
The fiber end-face is placed
Left/right fiber
on the electrode centerline
place error
or beyond it.
The fiber is not correctly
Pushing motor
placed at the bottom of the
surpass limit
V-groove.
1) The value of overlap is
Fiber end face in
set too low.
touch
2) Motor is not calibrated.
1) The fiber is not put
correctly at the bottom of
the V-groove.
Fiber tracking
2) The fiber is not located
failed
in the camera's field of
view.
3) The cleaved length
(bare fiber part) is too short.
Cleave angle
1) Bad quality of fiber
abnormal
end-face.
Solution
Press RESET, and set the fiber and
end-face between the electrode centerline
and the V-groove edge.
Press RESET, and put the fiber correctly.
1) Adjust [overlap] parameter.
2) [Motor calibration] maintenance.
1) Press RESET and replace the fiber
correctly at the bottom of the V-groove.
2) Check the position of stripped fiber on
the fiber cleaver.
3) Check the cleaved length.
1) Prepare fiber again. If problem
remains, check the condition of the blade.
47
Advertisement
Table of Contents
