Table of Contents
Advertisement
2) [Clean angle limit] is set
too low.
1) [Clean angle limit] is set
Core angle
too low.
2) There is dust on
abnormal
V-groove or fiber clamp.
1) Dust or dirt is on the
fiber surface.
2) Dust or dirt is on the
Fiber is dirty
objective lens.
3) [Clean ARC] time is too
short.
10.3 Common faults and solutions
Fault
Press ON/OFF key, cannot turn
on/off the machine
If the blade is worn, rotate the blade.
2) Set the [Clean angle limit] to a proper
value. (standard 3.0°)
1) Set the [Clean angle limit] to a proper
value. (standard 1.0°)
2) Clean the V-groove and fiber clamp,
and prepare the fiber and put it again.
1) Completely prepare the fiber again.
2) Clean the lens and execute [dust
checking], clean the lens if dust or dirt
exists.
3) Set the [Clean ARC] time to 180ms.
Solution
Press the ON/OFF key for long time till the LED lights
flickers, release the key, fusion splicer shut off.
48
Advertisement
Table of Contents
