Table of Contents
Advertisement
Overlap
Clean discharge time
Clean discharge strength
Prefabricated discharge
strength
Prefabricated discharge
time
Set the overlap amount of fiber pushing, if the [pre-discharging
strength] is low, then smaller [overlap] is recommended and vice
versa.
The clean discharge can burn the tiny dust on the surface of the
fiber in a small discharge cycle, and the discharge time can be
changed by this parameter.
Set clean discharge ARC strength.
Set the pre-discharge strength from the start of discharging to fiber
pushing. If [pre-discharging strength] is set too low, then the axial
deviation of the fiber will occur when the fiber cleaving angle is
relatively poor. If too high, excessive melting of optical fiber ends
will lead to greater loss of fusion.
It is possible to set the same discharge time from the start to the
start of the fiber advance, and the long [pre-fusing discharge time]
and the high [pre-fusing discharge intensity] result in the same
result.
25
Advertisement
Table of Contents
