Table of Contents
Advertisement
Pause one
Pause two
Alignment again
Faulty ignorance
Pull test
If [pause one] is set "on", splicing will be ended when
the fiber is pushed in right place, and user can see the
cleaving angle.
If [pause two] is set "on", splicing will be ended after
completion of alignment.
Alignment will lose efficacy after long state of [pause
two], after which, fusion splicer will align again. If
Alignment again is set "off", when fiber axial
displace, it's suggested to choose manual splicing
mode instead of alignment again mode.
Neglect the splicing fault, such as the cleaving angle is
bigger than the maximum value. If set this function
"on", splicing can be continued.
If pull test is set "on", then when splicing completed,
turn on the winder-proof cap, pull test could be
executed.
28
Advertisement
Table of Contents
