1) Poor quality of fiber
end face.
Dust combustion
2) Dust is not cleaned or
cleared when cleaning
the fiber or discharging.
1) Poor quality of fiber
end face.
Bubble
2) Low discharging
strength or short
discharging time.
1) Fiber pushing is too
small.
Fiber separation
2) High discharging
strength or long
discharging time.
Too thick
Fiber pushing is too big.
45
1) Check the fiber
cleaver working state.
2) Clear the fiber or
increase the [cleaning
discharging time].
1) Check the fiber
cleaver working state.
2) Enlarge [discharging
strength] and/or
[discharging time].
1) Perform [ARC
calibration]
maintenance.
2) Reduce [discharging
strength] and/or
[discharging time].
Reduce [overlap
amount] and execute
[ARC calibration].