Chapter 10 Operation Faults And Solutions; Excessive Splicing Loss And Solutions - Saluki SFS-7000 Series User Manual

Chapter 10 Operation Faults and Solutions

10.1 Excessive Splicing Loss and Solutions

Image Definition Reason
Fiber core axial There is dust on the
deviation V-groove or fiber clamp.
1) There is dust on
Fiber core angle V-groove or fiber clamp.
error 2) Poor quality of fiber
end face.
1) Poor quality of fiber
end face.
Fiber core
2) Low discharging
bending
strength or short
discharging time.
Fiber diameter Discharging strength too
mismatch low.
44
Solution
Clean V-groove and
fiber clamp.
1) Clean V-groove and
fiber clamp.
2) Check the fiber
cleaver working state.
1) Check the fiber
cleaver working state.
2) Enlarge [discharging
strength] and/or
[discharging time].
Enlarge [discharging
strength] and/or
[discharging time].