Editing Custom Tekcolor Corrections Overview; Editing Hints - Xerox 7700 User Manual

Editing Custom
TekColor Corrections

Editing Custom TekColor Corrections Overview

Use Edit Profile to make minor color changes in a PhaserMatch custom Device Link Profile.
The edited version of the device link profile will become a custom TekColor correction once it
is downloaded to the printer.
To begin editing:
1.
Launch the PhaserMatch application.
2.
Click on the Edit Profile button in the main screen.
Note: See Creating Device Link Profiles
profiles.
3.
You can either use the default preview image or select a different CMYK or RGB tiff
image.
Note: The preview image is used in the editing screen to show the changes you are
making to the color correction being edited.
After selecting a device link profile and a preview image, continue the process of generating a
new custom TekColor correction by clicking the Next button. After you are done with each
subsequent editing step in this process, click the Next button to have PhaserMatch walk you
through the steps needed to create custom TekColor corrections.

Editing Hints

Editing is best done in a series of small steps. While editing, you can make a small change and
print the results. Then continue by repeating this operation until you get the desired results.
Finally after making incremental changes, if the results are satisfactory, click the Next button
in the application to save the results and create a new custom TekColor correction. If the
results do not meet your needs, click the Close button in the edit window and start again.
on page 3-1 for information about device link
PhaserMatch and PhaserCal 4.0 User Guide
5-1