Related Manuals for ROTOTILT ICS Direct
Summary of Contents for ROTOTILT ICS Direct
- Page 1 Control System - ICS Direct Track Control Translation of the Original Instructions 2200399 _7733 2019-08-19...
- Page 2 Overview The product described in the document consists of components for the ICS Direct track control system. The overviews show standard equipment and options. Refer to the illustrations and lists below and on the following pages. ICS Direct is design to facilitate the movement of the base machine/excavator when working. ICS Direct track control is manoeuvred using switches and or rollers in the handles.
-
Page 3: Control Unit
Alternative alternative control is installed on the base steering inactive machine/excavator. ICS Direct When ICS Direct is activated the lamp activated lights. When the operation inhibitor is activated the lamp flashes to warn that the system is switched off. © Rototilt Group AB... - Page 4 On the decal, on the display and - The base machine/excavator’s factory mounted handles have been replaced with handles in the instructions for the base machine/ adapted for ICS Direct. excavator. Carefully check the changed functions, for both the base machine/excavator and alternative control.
-
Page 5: Operation
Warning Flashing light deactivated so that the system has the Sound 3 sec. requisite servo pressure. Also applies if ICS Direct is not connected to the inhibitor. Activate and deactivate with the switch in the handle. Malfunctioning IMPORTANT - If you suspect alternative control if malfunctioning, always use the base machine/excavator’s... - Page 6 (proportional control). The output signal from the handle is routed to the valve block (ICS Direct), which in turn activates the hydraulic motors of both tracks to move them at the same speed and in the same direction.
-
Page 7: Detailed Troubleshooting
Troubleshooting ICS Direct The control unit has two diodes and a buzzer, which indicate how the control system is working. The components light and sound at different intervals and combinations. The components are controlled by the signals that pass between the control unit and the other parts of the control system. -
Page 8: Input Signal
Check the harness in terms of crush slowly. at the pressure sensor. damage or open circuit. same rate as • Check the sensor the green LED. • Contact the service workshop. © Rototilt Group AB 2200399_ _7733 2019-08-16 English EN - trouble:2... -
Page 9: Output Signal
• Restart the control system. the green • Contact the service workshop. LED. To reset the fault indication, restart the system by disconnecting the voltage on the base machine. © Rototilt Group AB 2200399_ _7733 2019-08-16 English EN - trouble:3... - Page 10 More extensive adjustments and repairs must be done by Valveblock, Track Control an authorized service workshop. ICS Direct Track Control can be adapted with two alternative options for Valve Block. Both Valve Blocks are connected to the same functions for the system.
- Page 11 Valveblock, Track Control ICS Direct Track Control can be adapted with two alternative options for Valve Block. Both Valve Blocks are connected to the same functions for the system. Illustration below shows the the Valve Block applicable for certain machineadapted systems.
- Page 12 Harness ICS Direct General version © Rototilt Group AB 2200399_ _7733 2019-08-19 English EN - schema:3...
- Page 13 Hose connections ICS Direct ICS Direct MAIN VALVE BLOCK - BASE MACHINE ORIGINAL VALVE PEDAL MAIN VALVE BLOCK - BASE MACHINE ORIGINAL VALVE PEDAL © Rototilt Group AB 2200399_ _7733 2019-08-19 English EN - schema:4...
Need help?
Do you have a question about the ICS Direct and is the answer not in the manual?
Questions and answers