NDS POWERSERVICE PLUS 25 User Manual page 27

Warnings, possible problems and solutions
signal
All the LEDs
flash 5 times
accompanied by
the sound of
the buzzer.
All the LEDs
flash 10 times
accompanied by
the sound of
the buzzer.
pauses and
repeats
Central LED
flashing
problem
1. Fuse failure related
to the cable
connected to the
output.
2. solar panel voltage
too high.
3. electronic board
overheating.
Internal electronics
problems
problem with the d+
solution
check the integrity of the 2 x
25A fuses at the "out" pin.
check for bad connections.
check that the solar panel
voltage (pin 7) is less than
27V. wait for the system to
cool down and restart the
device at full speed (with
battery not fully charged)
Reset the device: disconnect
the cable attached at
terminal 3 for 10 seconds
and reinsert it. run te system
at full power (ie with the
battery not fully charged)
for 30 minutes. If the
problem occurs again
contact NDS support.
follow the steps below:
1. disconnect the cable on
terminal 3
2. wait 10 seconds
3. select 0 on the main
switch
4. connect the cable back to
terminal 3
5. wait for the buzzer sound
at the same time flashing
the 3 LEDs
6. set the switch to 1
7. if everything is ok, turn on
the engine.
8. put the switch first on 0,
then on 1, making sure that
the device turns on and
off without a problem.
27