Advertisement
5-4 BRAKES
1 . Secondary Shoe And Lining
2 . Return Spring
3 . Actuating Link
4 . Guide Plate
5 . Return Spring
6 . Primary Shoe And Lining
7 . Washer
8 . Clip
9 . Wheel Cylinder
10 . Pivot
11 . Strut
12 . Spring
13 . Override Spring
14 . Adjuster Lever
15 . Washer
16 . Hold Down Spring
17 . Pin
18 . Spring
19 . Nut
20 . Adjusting Screw
21 . Washer
22 . Socket
23 . Return Spring
24 . Lever
A-4129
6 . Engage the actuating link with the over-
ride pivot .
Then position the adjuster lever
and return spring on
the secondary shoe .
Position sleeve in the hole in secondary shoe
and fasten to backing plate with hold-down
spring assembly and pin.
7 . Install the remaining primary hold-down
spring, washer and pin.
8 . Install the primary and secondary brake
shoe return springs .
9 . Install hub and drum assembly . Refer to
Figure 7-Brake Assembly (Rear)
BRAKE DRUM INSTALLATION .
10 . Adjust brake shoes as outlined under
BRAKE SHOE ADJUSTMENT .
11 . If wheel cylinder was removed, bleed
brakes.
12 . Check fluid level in master cylinder.
Fluid level should be no more than 1/4" below
the reservoir opening at rear .
13 . Install wheel and tire assembly. Refer to
Section 10 of Maintenance Manual X-7525 for
details.
Advertisement
