Advertisement
CIRCUIT BREAKER ASSEMBLY
BOLT "B"
TORQUE 95-145 IN .LBS .
POWER CONVERTER
"D
INO
BATH FRONT BULKHEAD (REF)
POWER CONVERTER RECEPTACLE
REAR MOUNTING BRACKET
CONVERTER GROUND
SIDE MOUNTING BRACKET
BOLT
TORQUE 95-145 (N . LBS.
FRONT MOUNTING BRACKET
A-5539
Disconnect converter ground wire from frame.
Disconnect converter feed at circuit breaker .
NOTE : This circuit breaker is an automatic
reset type, rated at 60 amps.
6 . Remove two bracket bolts "B" and "C"
(figure 8) securing side bracket to furnace
mounting bracket .
Next, remove front and
rear bracket bolts "D" and "E" (figure 8),
closest to vehicle
interior .
Lift off rear
mounting bracket .
7 . Loosen remaining front bracket bolt "F",
and rotate front mounting bracket forward,
allowing converter to be pulled out . Converter
will be removed with side mounting bracket
attached .
8 . Remove side mounting bracket from con-
verter .
Secure
to
replacement
converter
assembly .
Refer to figure 8 for torque values
(bolts "B" and "C") .
CONVERTER REPLACEMENT
1. Disconnect battery ground cable from
living area battery .
Unplug converter at 120-
volt outlet.
Figure 8-Converter Installation (Model ZE06582)
MODEL ZE06581
LIVING AREA ELECTRICAL 2413-7
9 . Converter installation is reverse of re-
moval procedure .
Tighten all attaching parts
to torque indicated in figure 8 .
EXTERIOR RECEPTACLE
The optional exterior receptacle in model
ZE06582 is located on the right side of the
vehicle, behind the refrigerator grille .
The
exterior receptacle is wired into circuit #3 in
the circuit breaker panel, which is ground fault
protected . This is designed to protect anyone
using appliances that are plugged into this
receptacle from the hazards of line to ground
electric shock .
If an appliance continuously trips the circuit
breaker, the appliance is defective and should
be repaired or replaced .
2.
Disconnect converter lead at fuse panel.
(See figure 9 .)
3. Remove converter mounting bolts (4) .
(Refer to figure 9 .) Pull converter forward (or
BOLT "A"
BOLT
TORQUE 60-901N .LBS .
TORQUE 95-145 IN .LBS .
BOLT "D"
BOLT
"E"
TORQUE 60-90 IN .LBS .
TORQUE 95-145 (NABS.
Advertisement
