Advertisement
BODY 1A- 1 3
ENTRANCE DOOR
DOOR STRAP
The vehicle entrance door now has a check
strap (figure 12) to prevent the door from
opening out too far and making contact with
the body panel.
The strap assembly and
bracket
hardware
may
be
replaced
if
necessary .
Figure 12-Door Strap
END CAP
NOTE: When installing new or repaired rear access panel, 32 retaining screws are
needed . The seven lower screws are self tapping . The remaining 25 screws, on
the sides and top of the rear access panel, are double helix thread ("hi-low")
screws. To prevent damage to the threads in the vehicle fiberglass body when hi-
low screws are installed, be sure to position screw in hole and then rotate
counterclockwise . IMPORTANT : Before screws are installed, sealing is required
to prevent water leaks in the vehicle .
Using a caulking gun or any suitable
applicator, apply a small amount of clear, air-dry rubber-based sealer into the
screw holes in the fiberglass body .
Sealer can be a butyl-type sealer, an RTV
silicone, a windshield repair sealer, or equivalent .
FLOOR
GENERAL INFORMATION
figure 13 for typical layout.
Note that sub-
The floor and floor sub-structure in late
structure may vary with specific optional
model 1976 vehicles have changed .
Refer to
equipment.
Advertisement
