Advertisement
24J-2 LIVING AREA WATER SYSTEM
4. Turn on water pump and operate faucet .
Check for leaks.
NOTE : For a reverse water supply installat-
ion (cold water supply on the left and hot
water on the right), it is only necessary to
remove the faucet handle and rotate the
cam 1800.
Reinstall faucet handle and
check for proper operation .
SHOWER FAUCET
REMOVAL
1. Turn off water pump at water pump
switch located beside entrance door .
Open
faucet to reduce line pressure .
2. Remove screws retaining track of vanity
compartment located underneath
bathroom
sink . Note that 12-volt living area fuse block
is located in this compartment .
Remove
compartment only sufficiently to' gain access
to shower faucet.
3 . Tag water lines (hot and cold) for install-
ation.
Disconnect water lines from back of
faucet .
4. Remove elbows from backside of faucet .
5. Remove retaining nuts and washers that
hold faucet to shower wall. Remove faucet .
6. Disconnect hose to shower head from
faucet .
REPAIR
The shower faucet can be repaired by
procuring parts from a local plumbing supply
distributor.
INSTALLATION
1. Connect hose from
shower
head
to
faucet .
2. Position faucet on shower wall .
Install
washers and retaining nuts that hold faucet to
shower wall.
3. Install two elbows to backside of faucet.
4. Connect water lines to elbows on back of
faucet .
5 . Turn on water pump and operate shower.
ks.
BATHROOM SINK FAUCET
REMOVAL
1. Turn off water pump at water pump
switch beside entrance door. Open faucet to
reduce line pressure .
2. Remove doors from vanity compartment
underneath bathroom sink .
3. Disconnect water lines from faucet .
4. Remove retaining nuts that hold faucet
to sink . Remove faucet.
REPAIR
The bathroom sink faucet can be repaired by
procuring parts from a local plumbing supply
distributor.
INSTALLATION
1. Position faucet on sink . Install retaining
nuts that hold faucet to sink .
2. Connect water lines to faucets.
3. Turn on water pump and operate faucet.
Check for leaks.
4. Install
doors
in
vanity
compartment
underneath sink .
WATER TANK
REMOVAL
1. Remove bolsters (back cushions), if so
equipped, from right rear corner of vehicle.
2. Remove right twin bed to gain access to
water compartment .
3. Turn off water pump at switch beside
entrance door.
Turn off water heater at
switch located in bathroom .
4. Open tank drain valve and allow tank to
drain (see figure 1) .
5 . Disconnect inlet, outlet, and vent hoses
from tank .
6. Disconnect the tank hold down straps .
7. Remove water tank .
WATER PUMP
NOTE : Do not cut straps to remove tank .
INSTALLATION
1. Position tank in water compartment.
2. Connect tank hold down straps.
3. Install inlet, outlet, and vent hoses on
water tank.
4. Close water tank drain valve (see figure
1).
5. Fill water tank and turn on water pump
to pressurize the system . Check for leaks.
6. Install right twin bed over water com-
partment
7. Install bolsters (back cushions), if so
equipped, in right rear corner of vehicle .
REMOVAL
1. Remove bolsters (back cushions), if so
equipped, from right rear corner of vehicle .
2. Remove right twin bed to gain access to
water compartment.
Advertisement
