Image Area, Bleeds And Folds - Xerox 2000 Owner's Manual

Where offset has a total ink limit of around 350%, digital printing has a lower limit of
around 280%. This requires images to have UCR or GCR applied either at the time of
scanning, or when they are RIPped. If you scan images with UCR, do so with a maximum
ink limit of 280%. The Creo and Fiery RIPs used with the DocuColor 2000 Series will
automatically apply ink reductions to jobs when RIPping and limit ink to 280% (or any
other amount with the Creo). This ink reduction does not affect image quality.
Note that the total ink limit refers to the maximum amount of ink or toner in any given
area on the paper, such as in a black area. To calculate, add together the CMYK dot
percentage values in the darkest area in the image, eg, C96, M88, Y88 and K75 =
96+88+88+75 = 347%. The theoretical maximum is 400% (100% each of C, M, Y and K).

Image area, bleeds and folds

The maximum sheet size the DocuColor 2045 and 2060 will accept is 320 x 488 mm,
however this is a non-standard sheet size and not readily available (it must be cut to
order). SRA3 – 320 x 450 mm – is the most commonly used sheet with a maximum
image area of 312 x 442 mm.
A3 size
297 x 420 mm
SRA3 paper size
320 x 450 mm
The DocuColor 2000 Series presses will accept standard paper sizes of A4, A3 and SRA3,
as well as non-standard paper sizes from 182 mm to 320 mm in height and 182 mm to
488 mm in width. They will print to within 4 mm of each paper edge. The following
illustrations highlight the image area for different paper sizes.
DocuColor 2000 series design guide
3 - 4
Maximum image size
312 x 442 mm