Adjustment Of The Azimuth - Clearaudio TT3 User Manual

User manual / Bedienungsanleitung
If necessary, a correction can be made using the height adjustment screw (Pic. 23).
Pic. 23: Height adjustment
7.2 Adjustment of the azimuth (vertical position of the cartridge)
a
a = b
Pic. 24: Azimuth adjustment
Lower the cartridge onto the platter and check the azimuth level with the bubble of the Mini Level
Gauge. With the cartridge raised away from the record surface, slightly loosen the headshell tube
locking screw and rotate the headshell in the appropriate direction to set the correct azimuth.
When the adjustment is complete, re-tighten the headshell tube locking screw and remove the Mini
Level Gauge from the headshell. Now you can set the correct tracking force of your cartridge according
to the manufacturer's instructions. For the correct setting we recommend using the Clearaudio
Weight Watcher digital cartridge scale (Art. No. AC094, also available at www.analogshop.de).
14
Please be extremely careful during the following
steps. Please always lift the cartridge away from
the record surface.
Adjust the approximate fore/aft position of the cartridge.
The optimal distance of the stylus to the middle of the
headshell carriage is 62mm.
b
Use the Mini Level Gauge provided for the following azimuth
setting.
Place the gauge centered on the top of the headshell
(see Pic. 24) of the raised cartridge.
© clearaudio electronic GmbH, 2019-04