Minelab F3 Compact Operation Manual page 13

Figure 8: Connecting the Earset
NOTE
The Earset connector is waterproof and must be connected and disconnected from
the Earset socket by holding the rubber collar.
Do not attempt to connect or disconnect the Earset by pushing or pulling on the
strain relief or wire at the rear of the rubber collar.
The F3 Compact is now ready for use. Refer to "Functional Description" on
page 14 for controls, display, and functional information. Refer to "Operating
Procedures" on page 22 for detailed detector operation guidance.
To repack the F3 Compact, this preparation procedure should be reversed.
F3 Compact Operations Manual General Description and Preparation | 13