Installation Guide; Inspecting Shipment; Unpacking; Leveling - Challenge SCM Instructions And Parts Manual

Hide thumbs Also See for SCM:

Table of Contents

6.0 Installation Guide

The cornering machine has been carefully packed to prevent damage during shipment. However,

claims for damage or loss are the responsibility of the recipient. Inspect all shipments as soon as

they are received. If there is any noticeable damage, note it on the freight bill. Visual and/or hidden

damage must be reported to the claims department of the carrier within 15 days. Contact your dealer

if you need any assistance. Check the contents of the crate against the packing list on page 6. Make

sure there are no missing items.

Remove the packing materials and braces. Use a safe material handling device to lift the machine off

the skid. Secure the machine to any lifting or moving device using lifting straps. The machine weighs

over 250 lbs. (113 kg). If no lifting or moving devices are used, use at least two people to move the

machine. The machine should be lifted by gripping the edges of the table. Do not push or pull the

machine. A tip hazard may result! Note that the installation location must have a 120 VAC wall

outlet nearby.

Once positioned, level the machine to the floor by turning one or more of the four levelers to the floor.

Turning a leveler clockwise moves it to the floor.

Figure 3 - Leveling

It may be necessary to clean the machine after installation. It may be cleaned with a solution of dish

soap and water. Do not use petroleum or acid based solvents to clean the machine. Damage may

result.

Insert the power plug into nearby wall outlet. The machine should operate on a 20 Amp circuit. If the

pump motor stalls or operates sluggishly, test the line voltage. To many machines on one circuit will

reduce the voltage to each, affecting their performance.

See Section 7.5 Knife and Die Change on page 12.

Table of Contents

Mscm