Table of Contents
Advertisement
There will be a more noticeable gap between the area of the knife and die that runs straight
after the radius.
Correct installation will look like the following diagram.
26. Securely tighten the die mounting screws.
27. Remove all tools from the table. Close the top cover and reconnect power to the machine.
28. Switch on the machine (SCM models only).
29. Depress and hold down the foot switch/foot pedal. Carefully remove the hitch pin or hold-down
block.
30. Release the foot switch/foot pedal.
31. Remove the knife change lock pin by following steps 2 through 10 in reverse order.
32. Reinstall the chip drawer.
7.6 Straight Diagonal Cutting
Adjusting the side gauge will change the length of a straight diagonal cut. This length should not
exceed 1" when cutting 4" thick piles. It is possible to cut piles 2" thick and below at 1-1/4" length of
diagonal. See section 7.4 Side and Back Gauge Adjustment for side gauge adjustment instructions.
Figure 10 – Knife and Die alignment
Figure 11 - Maximum Recommended Cut
7.0 User's Guide
15
Advertisement
Table of Contents
