Table of Contents
Advertisement
7.0 User's Guide
Wood Block
20. Release the foot switch/foot pedal.
21. Switch off the machine (SCM models only).
22. Place a piece of tissue paper between the knife and the die to ensure proper clearance as shown
in Figure 9.
23. Using the knife adjustment setscrew, adjust the knife until the cutting edge is 1/8" above the
surface on which the die mounts.
24. Securely tighten the knife mounting screw.
25. Adjust the die such that the radius of the die makes perfect contact with the radius of the knife.
Notice: As of November 2011, all Challenge dies have been redesigned to improve trimming of
the bottom sheets. You may notice differences between new dies and old style dies. Install new
dies as the old style dies were installed, but note the following differences:
The radius area of the die will fit more tightly into the radius area of the knife.
14
Figure 8 – Lock the Cutting Head Down
Figure 9 – Tissue Paper between Knife and Die
Hitch Pin
Advertisement
Table of Contents
