Advertisement
Adding an Optional Air Line
Filer-Regulator-Lubricator (FRL) Kit
Proper conditioning of compressed air help prolong the
life of your pump. In the FRL Kit, the filter removes
harmful dirt and moisture from the compressed air, the
regulator controls air to the pump and the lubricator pro-
vides automatic motor lubrication.
Graco FRL (Part No. 110149) should be mounted to the
Fas-Vac with the Mounting Kit (Part No. 224759).
1. Remove the two manifold screws, flat washers, and
lockwashers (A) from the pump.
2. Install the accessory bracket (B) so that its large
hole faces up.
3. Install the screws and lockwashers (do not use the
flat washers).
4. Remove the male quick disconnect fitting (20) from
the pump and install it in the air filter inlet (J).
F
. 4
IG
308154G
5. Hold the FRL with the air filter (H) to the left. Install
the gauge (C) in the back port of the regulator (not
the top) and turn it so the gauge faces up.
6. Install the plug (G) in the front port of the gauge.
7. Remove the lock ring (F) from the base of the air
regulator knob.
8. Angle the FRL into the bracket so the gauge slides
into the slot in the bracket.
9. Screw the lock ring (F) over the regulator knob to
secure the assembly to the bracket.
10. Install a 90° nylon connector (E) to the FRL outlet
on the side of the lubricator.
11. Install the other connector to the pump air restricter
inlet (not visible in F
12. Tighten the connectors in a position that allows easy
installation of the nylon tube (D). Install tube.
C
B
A
. 4).
IG
D
G
J
H
20
Installation
E
F
7
Advertisement
