inventum BDA432 Instruction Manual page 35

Besides providing inaccurate readings, the effects of this device on the fetus are unknown.
• Too frequent and consecutive measurements could cause disturbances in blood circulation and injuries.
• When not in use, store the device in a dry room and protect it against extreme moisture, heat, lint, dust and direct sunlight. Never place
any heavy objects on the storage case.
• This device may be used only for the purpose described in this booklet. The manufacturer cannot be held liable for damage caused by
incorrect application.
• This device comprises sensitive components and must be treated with caution. Observe the storage and operating conditions described
in this booklet.
• The equipment is not AP/APG equipment and not suitable for use in the presence of a flammable anesthetic mixture with air of with
oxygen or nitrous oxide.
• Warning: No servicing/maintenance while the ME equipment is in use.
• The patient is an intended operator.
• The patient can measure data and change batteries under normal circumstances and maintain the device and its accessories according
to the user manual.
• The blood pressure monitor and the cuff are suitable for use within the patient environment. If you are allergic to polyester, nylon or
plastic, please don't use this device.
• If you experience discomfort during a measurement, such as pain in the arm or other complaints, press the START/STOP button to
release the air immediately from the cuff. Loosen the cuff and remove it from your arm.
• Before use, make sure the device functions safely and is in proper working condition. Check the device, do not use the device if it is
damaged in any way. The continuous use of a damaged unit may cause injury, improper results, or serious danger.
• Keep the unit out of reach of infants, young children or pets to avoid inhalation or swallowing of small parts. It is dangerous or even fatal.
• Be careful to strangulation due to cables and hoses, particularly due to excessive length.
• At least 30 min required for ME equipment to warm from the minimum storage temperature between uses until it is ready for intended
use. At least 30 min required for ME equipment to cool from the maximum storage temperature between uses until it is ready for
intended use.
• This equipment needs to be installed and put into service in accordance with the information provided in the ACCOMPANYING
DOCUMENTS;
35
English •