Troubleshooting Guide - Dakota Digital ARC-1000 Manual

Air bag control system
Table of Contents

Advertisement

TROUBLE SHOOTING GUIDE
IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are
going to be working on or under the vehicle. Failure to do so can result in serious injury if the
system is accidentally activated.
Symptom
----------------------------------------------------------------------------------------------------------------------------------------------------
System will not operate any of the
solenoids.
Air solenoids 'jump'
or 'chatter'.
Bags change direction in
mid-travel.
Transmitter has very short range
on all functions.
When the system is ready to receive a transmitter signal, the green light should be flashing slowly. If it is not, begin
checking the power and ground connections.
If none of these solutions solve the problem, or the problem occurring is not listed here, please call the Dakota
Digital technical assistance line at (605) 332-6513 for further assistance or email to
dakotasupport@dakotadigital.com.
Possible Problem
Receiver is not getting
power.
Ignition key is on.
Accessory input is powered
Remote module is not plugged in.
System is in display test mode
Weak or poor 12 volt connection.
Over loaded 12 volt power circuit.
Weak car battery.
Transmitter signal is being disrupted.
Transmitter battery is weak.
Antenna needs repositioning
st
4510 W. 61
St. N.
Sioux Falls, SD 57107
Phone: (605) 332-6513
FAX: (605) 339-4106
5
Solution
Check 12 volt connection.
Check ground connection.
Check fuses.
Turn off ignition.
Check connection to Acc. wire.
Connect connections.
Check Switch #4
Check 12 volt connection.
Move to new terminal point.
Place receiver and windows on
separate circuits.
Check for loose connections.
Increase wire size on power.
Recharge or replace car battery.
Move antenna away from power
wires.
See Battery Replacement.
Move antenna out away from
any high current wires.

Advertisement

Table of Contents
loading

Table of Contents