Table of Contents
Advertisement
PROGRAMMING SWITCHES
There are four programming switches located next to the main harness connector. They are used to set up
the operation of the remote system.
Switch #1
Select sender type
Switch #2
Select operation mode. (not used for control system)
Switch #3
Select bag dump time. (not used for control system)
Switch #4
Enter display test mode.
Display Mounting:
The display will require a rectangular cutout in 5-3/16" wide and 1-5/8" high. Insert the display
module into the opening from the front and place the two clamps provided onto the back side to
secure it into your dash.
10
Advertisement
Table of Contents
