Table of Contents
Advertisement
Auto program:
To enter the setup mode for one of the height settings press the setup select switch and the
appropriate corner switch at the same time. Press the mode select switch to go to the
auto/manual or auto select screens.
Use the up/down select and the corner switches to adjust the vehicle to the desired ride height.
Once the desired height is set, press the setup store switch to save the settings and return to
the auto control mode.
LEFT FRONT CONTROL
SETUP STORE
LEFT REAR CONTROL
Senders:
This system can be used with 2 senders (front/rear), 3 senders (front/rear & tank), 4 senders (4
corners), or 5 senders (4 corners & tank). The bag senders can be either Dakota Digital SEN-
03-1, 150 psi senders or Dakota Digital SEN-03-5, 400 psi senders. The tank sender is always
a SEN-03-5, 400 psi sender. Programming switch #1 is used to indicate which sender is being
used with the system. Place the switch on for 150 psi or off for 400 psi. The gauge resolution
will be 1 psi for 150 range and 2 psi for the 400 range.
The 150 psi senders have one terminal for connection to the controller. They need to be
grounded through their mounting threads. They either need to be screwed directly into a metal
fitting that is grounded or a ground wire needs to be clamped to the sender case. The ground
should be connected back to the same ground used for the main controller harness.
The 400 psi senders have two terminals. One terminal should be connected to the main
controller ground and the other terminal connected to the appropriate sender wire from the
harness. It does not matter which terminal is used for the ground.
TANK PSI
LEFT FRONT PSI
AIR 100 F 101 MANUAL
ADJ 105 R 106
LEFT REAR PSI
RIGHT REAR PSI
RIGHT FRONT PSI
UP
UP/DOWN CONTROL INDICATION
8
RIGHT FRONT CONTROL
UP/DOWN SELECT
RIGHT REAR CONTROL
Advertisement
Table of Contents
