Advertisement
2. Remove the stock gauges, separator plate, and lens from the bezel. The only item to be reused is
the original front bezel; the other pieces can be discarded. Now is a good time to clean or refinish
the bezel.
3. Peel the paper off the two block off lenses that
match the bezel and, on the back of the housing,
place them shiny side down in the two indicator
openings in the center (white arrows). Use silicone
to hold them in place and avoid handling until the
block off lenses are secure.
4. Place the VHX spacer over the back of the bezel so the flat side with three counter sunk holes is
facing you; make sure the counter sunk holes (white arrows) line up with the bezel mounting
points. Use the three (3) provided 1/2" 6-20 flat head screws to secure the spacer to the bezel.
Manual # 650421B
Advertisement
