Table of Contents
Advertisement
OVENLIGHT
The storagedrawercan be removedto
TO REPLACE:
allowyoutocleanunderthe range.
Fit the frontedge of the ovenbottom
into the oven-frontframe. Lower the
TO REMOVE:
rear of the oven bottom and slide the
two catchesbackto lock the oven bot-
> Disconnect power to range
1. Emptydrawerand pullout to the first tom in place.
beforereplacinglightbulb.
stop position.
Use a dry potholderto prevent
possible harm to hands when
2. Lift up the frontof the drawer.
ELECTRICAL
replacingbulb.
3. Pull out to secondstop position.
CONNECTION
Appliances which require electrical
Be sure bulb is cool before
4. Grasp sidesand lift drawer up and power are equipped with a three-
touchingbulb.
out.
prong grounding plug which must be
> Do not touch hot bulb with a
pluggeddirectlyinto a properlyground-
damp cloth as this may cause
the bulbto break.
TO REPLACE:
ed three-hole120 volt electricaloutlet.
1. Fitthe endsof the drawerglidesinto Alwaysdisconnect p owerto appliance
auL_ .....
the railsinthe range,
beforeservicing.
reero
2. Lift up front of drawer and gently grounding
plug
push in to the first stop position,
offers
protection
........
3. Lift drawerup again and push until against shock haz-
TO REPLACEOVENLIGHTBULB:
draweris closed,
ards. Do not cut or
remove the third !_
grounding
prong
1. Whenoven is cool, hold bulb cover
OVEN BOTTOM
from the power cord plug.
in place,then slide wire retainer off
cover.NOTE:Bulb cover will fall if
Protectoven bottomagainstspillovers, If an ungrounded,two-hole or other
not held in place while removing
especiallyacidic or sugary spills, as type electricaloutlet is encountered,it
wire retainer,
theymay discolorthe porcelainenamel, is the personal responsibility of the
Use the correct pan size to avoid appliance owner to have the outlet
2. Removebulb coverand light bulb.
spilloversand boilovers. Never place
replaced with a properly grounded
utensils or foil directly on the oven three-hole electrical outlet.
3. Replace with a 40-watt appliance bottom.
bulb.
The oven bottom may be removedfor
REMOVALOF
4. Replacebulb coverand securewith
easiercleaning.
GAS APPLIANCE
wireretainer.
TO REMOVE:
Gasappliance c onnectors u sedto connect
5. Reconnectpower to range. Reset
When cool, re-
_
_
this appliancetothe gas supplyare not
clock,
move the oven _
_
designed for continuous movement.
racks. Slide the _
_
Once installed, DO NOT repeatedly
two catches, Io- _'
-
move this gas appliance for cleaning
cated at each_f
--
or to relocate. If this appliance has to
STORAGEDRAWER
rear cornerof the _/__ t3_,
be moved and/or removed for servic-
(Selectmodels)
oven bottom, to- 4-
ing, follow the proceduredescribed in
wardthe front of the oven.
the installation instructions.For infor-
Lift the rear edge of the oven bottom mation contact Maytag Customer
slightly,then slide it backuntil the front Serviceat 1-800-688-9900.
_- Do not store plastic,paper prod-
edge of the oven bottom clears the To prevent range from accidently tip-
ucts,foodor flammablematerials
ovenfrontframe.Removeoven bottom ping, rangemust be securedto floor by
in this drawer.The drawer may
from oven.
becometoo warmfor theseitems
slidingthe rear levelingleg intothe anti-
whenthe oven is in use.
tip bracket.
Advertisement
Table of Contents
