Technical Specifications - Avaya 3500 Series Installation Instructions Manual

Installing the Avaya Ethernet Routing Switch 3500 Series
Preventing electrostatic damage in new cable installations
With new cable installations, Avaya recommends that you use an ESD discharge cable to reduce
the potential for damage from static, that can build up in cables. The following figure illustrates an
ESD cable.
Figure 2: ESD discharge cable
To install the ESD discharge cable, perform this procedure.
1. Connect the ground lug on the ESD discharge cable to a safe and suitable earth ground.
2. Connect all RJ-45 cable connectors to the female RJ-45 connector of the ESD discharge
cable for at least 5 seconds, and then connect each RJ-45 cable connector to the switch.
3. Leave cables connected to the networking equipment. After you connect cables to
networking equipment, the cables do not build up charge.

Technical specifications

The following table provides the technical specifications for the individual switches in the Avaya
Ethernet Routing Switch 3500 Series. Ensure that the area where you install the switch and where it
operates meets these requirements.
Warning:
To avoid bodily injury from hazardous electrical shock and current, never remove the top of the
device. No user-serviceable components are inside.
September 2016 Installing Avaya Ethernet Routing Switch 3500 Series
Comments on this document? infodev@avaya.com
16