Clas Ohlson 34-7710 Manual page 5

The mill is now ready for use
Push the start button, freshly ground pepper will come out of the
mill and the halogen light will come on. The pepper mill can be used
for: Pasta, sallad, pizza, soup, steak, etc. the halogen light illumina-
tes your plate helping you to see exactly where the pepper is going.
Adjusting the coarseness of the grounds
Turn the mill upside down, push
the start button and let the mill
run for a couple of seconds (this
makes the adjustment easier),
using your thumb and forefinger,
turn the adjusting screw whilst
holding the mill in your other hand.
Twist the screw clockwise for fine
grinding and anticlockwise for
coarse grinding.
Changing the halogen light bulb
Turn the mill upside down and turn the shutter until the lug lines up
with the  mark on the bottom of the mill. You can now remove the
shutter
Push in the two pins on the sides of the bulb socket, hold the
socket between your thumb and forefinger and carefully remove it
from the socket holder.
Take a new halogen bulb
(mounted in a socket) and
align the two pins on the
socket with the two small
holes in the holder.
Press the pins into
the holes and fol-
low the slots on the
side of the socket
holder until the bulb
is pushed all the
way into the holder.
Replace the shutter.
Disposal
Follow local ordinances when disposing of this product. If you are
unsure about how to dispose this product contact your municipality.
Coarser
View from underneath
Bayonet
mount
Halogen bulb
View from underneath


Finer
Adjusting
screw
Socket holder
Pin
Bulb socket