Advertisement
6. Time interval setting to read the same barcode
After reading a barcode, the scanner will not read the duplicate one within a certain
time interval you set. Default: 0.5s, Setting range: 0-9.9s. The function is only available
under Continuous Scanning Mode and Auto-induction Mode.
To set the time interval to read duplicate barcodes, for example:
6.1 To set the time interval to 0.5s, please scan the barcode below, and then scan "0"
and "5" in Appendix 1.
6.2 To set the time interval to 8s, please scan the barcode below, and then scan "8"
and "0" in Appendix 1.
7. Settings to read all kinds of codes
7.1 Setting for 1D Inverse Barcode
Under some situation the white and black can be inverse on a barcode. With the
settings below, the barcode scanner can scan both common barcode and the
inverse barcode.
（*）Disable to decode 1D inverse barcode
Note: The relevant setting codes for 2D inverse codes are listed in the settings below.
7.2 Enable to read all 1D barcodes
Enable to read all 1D barcodes
Time interval setting to read the duplicate barcode
Enable to decode 1D inverse barcode
Disable to read all 1D barcodes
3
Advertisement
