Smeg HOBD682D Manual page 4

Hide thumbs Also See for HOBD682D:
Table of Contents

Advertisement

For appliances with supply
cords, the arrangement of the
terminals, or the length of the
conductors between the cord
anchorage and the terminals,
shall be such that the current
carrying conductors become
taut before the earthing
conductor if the cord slips out
of the cord anchorage.
The manufacturer will not be
Z
X
held liable for any damages
resulting from incorrect or-
improper installation.
Check that the mains voltage
Z
X
corresponds to that indicated
on the rating plate fixed to the
inside of the product.
Means for disconnection must
Z
X
be incorporated in the fixed
wiring in accordance with the
wiring rules.
For Class I appliances, check
Z
X
that the domestic power
supply guarantees adequate
earthing.
Connect the extractor to
Z
X
the exhaust flue through
an adequate pipe. Please
refer to the purchasable
accessories shown in the
installation manual (if circular
pipe: minimum diameter 120
mm). The route of the flue
must be as short as possible.
Connect the product to
Z
X
the power net by using an
omnipolar switch.
26
Regulations concerning the
Z
X
discharge of air have to be
fulfilled.
Do not connect the extractor
Z
X
appliance to exhaust ducts
carrying combustion fumes
(boilers, fireplaces, etc.).
If the extractor is used
Z
X
in conjunction with non-
electrical appliances (e.g.
gas burning appliances), a
sufficient degree of aeration
must be guaranteed in the
room in order to prevent the
backflow of exhaust gas.
When the cooker appliance
is used in conjunction with
appliances supplied with
energy other than electric,
the negative pressure in the
room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by
the cooker appliance.
The air must not be
Z
X
discharged into a flue that is
used for exhausting fumes
from appliances burning gas
or other fuels.
If the supply cord is
Z
X
damaged, it must be replaced
from the manufacturer or
its service agent or similarly
qualified person in order to
avoid a hazard.
Connect the plug to a socket
Z
X
complying with current
regulations, located in an
accessible place.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hobd682r

Table of Contents