2: Panel Program Menu; 3: Lcd Display - Honeywell NOTIFIER LCD-160 Manual

Screen Displays
Programming screens, such as "Panel Programming" and "LCD Display" are not available unless
the programming switch is enabled. Once programming is completed, the switch must be "locked"
back into the non-programming position.
NOTE: Enabling the programming switch will cause a "Remote Display" trouble.
9.1.2 Panel Program Menu
Pressing the soft key to the right of
Menu." Use this screen to set the LCD-160's RDP circuit address and program local settings on the
LCD-160. This screen is only available when the Programming switch (SW17) is enabled. Refer to
"Setting the Programming Switch" on page 31.
Soft Keys

ADDRESS CHANGE
address will cycle from 1 to 32.
- Press this key to toggle the status of the piezo between
PIEZO
LCD DISPLAY
ACCEPT
Display." A confirmation screen will display before your new settings are saved.
- Press this key to return to the previous screen without saving information entered.
BACK
NOTE: Each device on the RDP bus must have a unique address.
9.1.3 LCD Display
Pressing the soft key to the right of
"LCD Display" screen. Use this screen to program the LCD-160's screen settings. The "LCD
Display" is only available when the Programming switch (SW17) is enabled.
32
PROGRAM
P A N E L P R O G R A M M E N U
A D D R E S S C H A N G E
P I E Z O : O N
B A C K
Figure 9.4 Panel Program Menu Screen
- Press this key to increase the LCD-160's address on the RDP bus. The
- Press this key to go to the "LCD Display" menu.
- Press this key to accept changes programmed in "Panel Program Menu" and "LCD
LCD DISPLAY
on the "Main Menu" brings up the "Panel Program
A D D R E S S : 0 7
L C D D I S P L A Y
OFF
on the "Panel Program Menu" brings up the
LCD-160 Manual — P/N 51850:D2 10/07/2016
Programming Screens
A C C E P T
and .
ON