Installation Overview - Honeywell NOTIFIER LCD-160 Manual

Installation Overview

Diagnostic LED Indicators
LED indicators 11 through 14 aid in troubleshooting the LCD-160 and are visible to the installer
only. Figure 3.1 shows the locations of the diagnostic LED indicators. Table 3.1 lists and describes
the function of each of these diagnostic LED indicators. LED Indicators 1 through 10 indicate
system status and are visible to the user. See "Status LED Indicators" on page 24 for information on
LED indicators 1 – 10.
Reference
LED11 STATUS
LED12 RECEIVE
LED13 TRANSMIT
LED14 MICROFAIL
3.4 Installation Overview
1. Mount and ground the cabinet or backbox (Section 5.1).
2. Pull wiring into backbox (Figure 5.1).
3. Configure RDP bus ELR DIP switch (Figure 6.4).
4. Connect Earth Ground to a mounting screw on the backbox or cabinet (Section 6.3).
5. Mount the optional Annunciator Key Switch (Section 6.5).
If mounting into a CAB-4 series backbox: (Section 4)
1. Mount the LCD-160 to the dress panel (Figure 5.2).
2. Mount the dress panel to the backbox.
3. Make all electrical connections:
• RDP bus & shielding if necessary. (Figures 6.2 & 6.3)
• Power circuit (Figure 6.6)
4. Attach doors to backboxes (Section 5.2).
5. Power up system according to instructions in the control panel manual.
6. Configure the LCD-160 (Section 9.1).
If mounting into an ABS-2D/4D or ABF-2B/4B backbox: (Section 4)
1. Make all electrical connections:
• RDP bus & shielding if necessary. (Figures 6.2 & 6.3)
• Power circuit (Figure 6.6)
2. Mount the LCD-160 in the backbox.
3. Attach doors to backboxes (Section 5.2).
4. Power up system according to instructions in the control panel manual.
5. Configure the LCD-160 (Section 9.1).
LCD-160 Manual — P/N 51850:D2 10/07/2016
LED Name Color
Green
Green
Green
Yellow
Table 3.1 Diagnostic LED Indicators
Description
Blinks when the LCD-160 is on.
• Installer/Troubleshooting only.
Blinks when data is received from the panel.
• Installer/Troubleshooting only.
Blinks when data is transmitted to the panel.
• Installer/Troubleshooting only.
Illuminates if the microcontroller fails.
• Installer/Troubleshooting only.
System Overview
11