Table of Contents
Advertisement
HP 70341A
0.5-1 GHz INPUT:
SMA connector accepts a 0.5 to 1.0 GHz signal from the HP 70340A that
drives the HP 70341A Frequency Extension module.
0.01-1 GHz OUTPUT:
SMA connector outputs a 0.01-1 GHz signal which extends the HP 70340A
frequency range down to 0.01 GHz. The HP 70341A signal is output step
attenuated in the HP 70340A with the 0.01 to 1.0 GHz output available at the
front panel RF Output connector of the HP 70340A.
ALC CTRL:
SMB connector accepts a 10 to +10 V signal as a reference for leveling the
.01 to 1.0 GHz output signal.
AM INPUT:
SMB connector accepts AM drive signals from the HP 70340A rear panel AM
OUTPUT connector.
PULSE INPUT:
SMB connector accepts pulse modulation drive signal from the HP 70340A
rear panel PULSE OUTPUT connector).
Options
There are several electrical, mechanical, warranty, and documentation
options available for the HP 70340A.
Electrical Options:
Generator. These options are as follows:
Option 1E1 - Add Output Step Attenuator
If option 1E1 is ordered, an internal step attenuator is included before the
RF OUTPUT
10 dB steps. The correct amount of attenuation is selected automatically by
the Signal Generator dependent on the output power level selected. If this
option is installed, you can select whether or not the step attenuator will
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
There are three electrical options available for the Signal
connector. The step attenuator has a range of 0 to 90 dB in
Reference
Speci cations- HP 70340A/41A
3-27
Advertisement
Table of Contents
