Table of Contents
Advertisement
Figure 4: Strain Relief Installation When Using Non-Strain Relief Round Cable
Lens and Legend Replacement
Using a small screwdriver, pry the lens out of the button hood by inserting the blade between the lip of the
hood and the lens. Be careful not to damage the button hood. Remove the legend and replace with the
selected word or symbol from the legend sheet. Insert the lens over the legend and make sure it is
secure.
Button Hood Replacement
Remove the switch under the button hood by unscrewing it. Tear the button hood off with pliers from the
outside. Remove the button hood retaining ring from the enclosure with a flat bladed screwdriver, taking
care not to damage the enclosure. Insert a new button hood with legend already in place from the outside
by pressing it in with both thumbs. Screw the switch back into place.
SBN Pendant Station Manual
October 2019
Page 14 of 19
Advertisement
Table of Contents
