Table of Contents
Advertisement
Application range:
TNH6-70
TND6-70
Weight
Dimensions:
length
width
2.1) Operator information:
- The instructions within this operation and maintenance manual should always be followed.
- The tool should only be used by competent personnel who are familiar with the instructions
contained within this manual.
2.2) Application:
Not to be used for any other purpose than for which the tools were designed
Do not use these crimping tools to crimp other type of lugs or connectors.
2.3) Die profile selection:
- Fully open the tool handles
- Press down the locking-pin of the indexable die plates.
- TNH6-70: Rotate the die profiles until the stamped cross section matches the cross section on
the cable lug/connector.
- TND6-70: Rotate the die profiles until the 'K' number matches the equivalent No. marked on
the palm of the terminal lug or the wall of the splice.
- Release the locking-pin until the die profile is fixed.
- Adjust the second die profile in the same manner as the first by following the above instruc-
tions. Both profile dies must have the same 'K' number.
1. GENERAL CHARACTERISTICS
- Copper tube terminal lugs type HR.. for conductor sizes
6mm
- Copper tube splices type HSV.. for conductor sizes 6mm
70mm
- Copper tube terminal lugs according to DIN46235 (Cembre
type DR..) for sizes 6mm
- Copper tube splices according to DIN46267 Part 1 (Cembre
type DSV..) for sizes 6mm
kg (lbs)
mm (inches)
2. INSTRUCTIONS FOR USE
2
to 70mm
2
2
to 70mm
2
to 70mm
2
2,1 (4.6)
515 (20.2)
132 (5.2)
2
to
2
2
2
Advertisement
Table of Contents
