Operation Instruction; Power On; Parameters Setting; Measure - DGC DHT-100Plus Instruction Manual

6. Operation instruction

6.1 Power on

Fit on the impact device firstly, press key
information is displayed.
1. Series No., Software version
2. Parameters of last setting
：
Notice If the impact device is not fitted properly, the instrument will not
be able to complete self-checking and will give out the Notice "Plug in the
impact device please".

6.2 Parameters setting

Various parameter settings and management can be accomplished via the
instrument menu. Press the
key or
confirm setting.

6.3 Measure

"Measure" is available for users to set basic parameters needed in
measurement. It can also be changed during the measurement operation.

6.3.1 Impact direction settings

DHT-100Plus can be used for hardness measuring in different directions,
but different direction meets different requirements, so it is very important to
select the proper impacting direction. Normally the direction is DOWN.
Hardness Tester DHT-100
key to select the setting items. Press the
PLUS
to power on. The following
key to Enter the menu, and press the
8
key to