Files Management; New File Settings; Storage Settings - DGC DHT-100Plus Instruction Manual

6.4 Files management

Via "file management", users are allowed to set the file management ways.
For example, users can set the saved file codes according to their own
requirements.
6.4.1 New files settings
Via this sub-menu, users are allowed to set the number of files freely.
DHT-100Plus hardness tester supplies users 100 files, which are coded from
F001 to F100. Per each file, there is also 100 data storage, which is coded
from 001 to 100. For example it shows F001-099 on LCD display, it means the
th
99 test data in File No. 001.
Users are also allowed to build only one file. When the auto-save is turned
on, the indication mark
will be saved in the file in a series of codes. When the memory is full, it will
give a Notice and said that "please build another file" or "the memory is full",
"please delete the data unused". When a new file is built, the former one will
be closed automatically, and at the same time it is featured "read only", which
means that users can only read or print out the former file but not write in.
-Press the
-Press the
-Press the
-Press the

6.4.2 Storage settings

Set the data auto-saving state during measurement by turning on or off.
When data saving is set on "auto saving", there will be a corresponding
indication mark
the file automatically, vice versa.
Hardness Tester DHT-100
appears on the screen, and the measured values
key and the
key to enter this item,
key or key for setting,
key to confirm.
on the screen, and the measuring values will be stored in
PLUS
key to enter FILES--SETUP NEW FILE,
12