Operation Instruction; Power On; Parameters Setting; Measure - DGC DHT- 200Plus Instruction Manual

6. Operation instruction

6.1 Power on

Fit on the impact device firstly, press key
information is displayed.
1. Instrument model, Series No., Software version
2. Parameters of last setting
：
Prompt If the impact device is not fitted properly, the instrument will not
be able to complete self-checking and will give out the Notice.

6.2 Parameters setting

Various parameter settings and management can be accomplished via the
instrument menu. Press the
key or
confirm setting.

6.3 Measure

"Measure "is available for users to set basic parameters needed in
measurement. It can also be changed during the measurement operation.

6.3.1 Impact direction settings

DHT-200 can be used for hardness measuring in different directions, but
PLUS
different direction meets different requirements, so it is very important to
select the proper impacting direction. Normally the direction is DOWN.
Hardness Tester DHT-200
key to Enter the menu, and press the
key to select the setting items. Press the
PLUS
to power on. The following
8
key to